Categories
Uncategorized

Ergonomics Assessment and Control

Read the background information in Section (I)
The paper should address each of the subsections of Section II.
Make sure you read each section completely and carefully before preparing your paper. The project should be
written in full (7th Edition APA format) and include the elements listed below.
Section I: Background
Acme General Contractors is the general contractor for a new 20-story commercial building in downtown
Centerville, USA. The building will use a rigid-frame structure and reinforced concrete construction.
A major subcontractor on the project who will be performing the roofing and interior insulation and drywall
installation has hired you as the safety officer.
Section II: Assignment
1. Analyze the hazards associated with the roofing and the interior work. You should identify at least three
hazards for each activity.
2. Perform a risk assessment on three of the hazards that you identified for each activity (six total) using the 4 X
5 matrix shown in Figure 34-1 on page 492 of the textbook or in the quantitative risk assessment form, which
can be accessed by clicking here.
3. Prioritize the need for controls for the hazards that you selected based on the results of the risk assessment.
4. Using the hierarchy of engineering controls listed in Figure 3-3 on page 29 of the textbook, recommend a
control method for each hazard that you believe would be the most effective in reducing risk to an acceptable
level. Explain why you made the choice, and support your decisions with at least one reference other than the
textbook.
5. Use the 4 X 5 matrix or the quantitative risk assessment form to show the reduction in risk for each hazard
after the control method has been applied.
6. For any fall protection that you recommend, be specific about the type of fall protection needed.
7. Discuss how Prevention through Design (PtD) could be used to reduce the risks associated with these
operations.
• Prepare your project in a properly formatted APA document including a title page, the body of the paper, and a
references page.
• The body of your paper must be a minimum of four pages in length and be double-spaced; the title page and
references page will not count toward meeting the four-page minimum requirement.
• The textbook must be used and at least two other source outside of the textbook as references

Leave a Reply

Your email address will not be published. Required fields are marked *